A-A-58028D
2.3.10 Auxiliary power outlet. The vehicle shall be equipped with one 12-volt, 15 amp,
protectively, capped auxiliary power outlet near the passenger-seated position for portable
electronic equipment. There shall also be one 12-volt, 15 amp, protectively capped auxiliary
power outlet near each crew cab seated position.
2.3.11 Cellular phone circuits. The vehicle shall have two dedicated 12 volt, 15 amp circuits,
with breakers and wires, routed, one each, to the work stations for the connection of cellular
phones.
2.3.12 Work station light circuit. The vehicle shall have a dedicated, switched, 12 volt, 15 amp
circuit, with breaker, connected to lights above each work station. The "ON"/"OFF" switch shall
be placed at the central work station.
2.3.13 Work station power points. The vehicle shall have two dedicated 12 volt, 20 amp circuits,
with breakers and wires, routed, one each, to the work stations. There shall be four 12-volt, 20
amp, power point connections at each work station.
2.4 Driving and crew areas.
2.4.1 Cab. The vehicle shall have a tilting or non-tilting cab with at least 3 doors for at least four
persons. The cab shall be of all aluminum or all stainless steel construction. Aluminum thickness
shall be at least 0.125 inches, except for door skins, which shall be at least 0.090 inches.
Stainless steel thickness shall be at least 0.090 inches. The cab shall have a wrap-around
windshield and a matching contour cab face. Cab door openings shall extend for the full vertical
height of the side panels. Steps and handrails shall be provided for all crew doors, and at least
one grab handle shall be provided for each crew member, located inside the cab for use while the
vehicle is in motion. A vehicle data recorder shall be added in provided with 4.11 of NFPA 1901.
Provisions must be made for fire helmet storage for all seated positions IAW 14.1.8 and 14.1.11
of NFPA 1901.
2.4.1.1 Command area. The command area shall have a raised roof with visibility to the sides.
Floor to ceiling height in the rear crew compartment shall be not less than 70 inches clear. The
cab rear crew area shall have an arrangement of two work stations. Each work station shall
include: a writing surface with clear space above, book storage shelving, and a drawer shall be
mounted below each workstation to accommodate administrative supplies. Also, a permanently
mounted swivel seat with backrest shall be included in the command area.
2.4.1.2 Seats. The driver's seat shall be of an adjustable air suspension design. The crew member
seats shall be of a non-suspension design. Each seat shall be provided with a Type 2 seat belt
assembly (i.e., 3-point restraint) in accordance with Code of Federal Regulations (CFR) 49 CFR
571.209 except for the two command chairs if inboard mounted may include Type 1 seat belts in
accordance with same CFR regulations. All seats shall be equipped with seat belt sensors in
compliance with 14.1.3.10 of NFPA 1901. All seat belts shall be red in color.
2.4.1.3 Cab interior sound level. The maximum sound level at any seat location shall not exceed
80 dBA without any warning devices in operation, as measured in accordance with 49 CFR
12
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business