A-A-58003F
IRT is engaged: in cab climate control system, radios, DOT truck lighting, NFPA required
emergency lights, step lights and compartment lights
2.11 Air systems.
2.11.1 Low-pressure utility air supply. A pressure protected air chuck, with a quick disconnect,
shall be provided, located on the driver's side of the vehicle for the operation of purchaser-
provided air tools. The air source shall be the vehicle air system.
2.12 Trailer towing package. The vehicle shall be equipped with a square sleeve type receiver
used to tow trailers equipped with a ball tow hitch and other ancillary firefighting equipment.
The tow hitch and receiver shall be rated at the maximum inherent towing capability of the
vehicle such that safety and reliability of the vehicle are not degraded. The trailer hitch shall
comply with 26.8.1 and 26.8.2 of NFPA 1901. The maximum towing capacity and tongue weight
capacity of the vehicle shall be clearly and visibly posted both near the tow hitch receiver and
inside the cab of the vehicle. The manufacturer shall describe any hazards, risks, maximum
suggested speed limits or restrictions, and special use requirements during the solicitation
process. This information shall also be listed near the tow hitch receiver, inside of the cab of the
vehicle, as well as in the operator's manual. A brake controller shall be provided for use with a
trailer which has an electric braking system. Gladhands in accordance with SAE J318 shall be
provided for use with a trailer which has an air braking system.
2.13 Safety chain attachment points. The vehicle shall be equipped with two safety chain
attachment points, one located on each side of the receiver sleeve, symmetrical about the receiver
sleeve. The vertical centerline of the safety chain attachment points shall be located at a parallel
distance of not greater than 6 inches to the left and right of the truck centerline. Safety chains
shall comply with 26.8.3 of NFPA 1901 and shall have the ability for standard safety chain
hooks to be attached. The inside radius of the safety chain hook is between 1 inch and 3 inches.
2.14 Workmanship. The vehicle, including all parts and accessories, shall be fabricated in a
thoroughly workmanlike manner. Particular attention shall be given to freedom from blemishes,
burrs, defects, and sharp edges; accuracy of dimensions, radii of fillets, and marking of parts and
assemblies; thoroughness of welding, brazing, soldering, riveting, and painting; alignment of
parts; tightness of fasteners; et cetera. Wire ties may be used for bundling vehicle wiring, but not
for support of wire bundles. Support must be provided by insulated metal clamps. The vehicle
shall be thoroughly cleaned of all foreign matter.
3. REGULATORY REQUIREMENTS.
3.1 Recycled, recovered, or environmentally preferable materials. Recycled, recovered, or
environmentally preferable materials should be used to the maximum extent possible provided
that the material meets or exceeds the operational and maintenance requirements, and promotes
economically advantageous life cycle costs. The offeror/contractor is encouraged to use
recovered materials to the maximum extent practicable, in accordance with 23.403 of the Federal
Acquisition Regulation (FAR). However, used, rebuilt, or refurbished items shall not be
provided.
19
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business