A-A-58009B
2.7.1 Air hose reels. Two air hose reels shall be provided, one ceiling mounted in a compartment
on each side. Each hose reel shall be equipped with 150 feet of 0.50 inch inside diameter
hoseline; a 3/8 inch National Pipe Taper (NPT) fitting and female style quick disconnect shall be
connected to the end of each hoseline. Hoselines shall be equipped with rubber ball stops to
prevent hose pull through on roller guides during rewinding operations. A four-way roller guide
shall be provided for each hose reel to prevent hose chafing and kinking. Each hose reel shall
have an electric rewind motor and provisions for manual rewind in the event of motor failure; the
manual rewind handle shall be securely stored near the hose reel. A pressure protected air supply
from the chassis air system shall be connected to each hose reel. The air supply lines shall be
routed with minimum bends and located or guarded from damage from the carried equipment.
2.8 Winch. A winch with at least 12,000 pound-pull shall be installed, recessed behind the front
bumper. The winch shall be electric or hydraulic powered and shall have one or more forward
and reverse speeds of not less than 15 feet per minute. The winch shall be equipped with a
minimum 125 feet of 3/8-inch galvanized aircraft cable, with 36 inch end chain and hook. The
winch shall include a four way cable guide. A 10 foot minimum remote control cable shall be
provided for operation of the winch. If an extended bumper is used, a cover fabricated of
treadplate shall be installed over the winch and the space between the cab and bumper.
2.9 Workmanship. The vehicle, including all parts and accessories, shall be fabricated in a
thoroughly workmanlike manner. Particular attention shall be given to freedom from blemishes,
burrs, defects, and sharp edges; accuracy of dimensions, radii of fillets, and marking of parts and
assemblies; thoroughness of welding, brazing, soldering, riveting, and painting; alignment of
parts; tightness of fasteners; et cetera. The vehicle shall be thoroughly cleaned of all foreign
matter.
3. REGULATORY REQUIREMENTS.
3.1 The offeror/contractor is encouraged to use recovered materials to the maximum extent
practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).
4. PRODUCT CONFORMANCE PROVISIONS
4.1 Product conformance. The products provided shall meet the salient characteristics of this
CID, conform to the producer's own drawings, specifications, standards, and quality assurance
practices, and be the same product offered for sale in the commercial marketplace. The
government reserves the right to require proof of such conformance.
4.2 Commercial item requirement. The vehicle furnished shall comply with the "commercial
item" definition of FAR 2.101 as of the date of award. The government reserves the right to
require the offeror/contractor to prove that their product complies with the referenced
commerciality requirements and each salient characteristic of this CID.
The offeror/contractor shall provide an itemized technical proposal that describes how the
proposed model complies with each salient characteristic of this CID; a paragraph by paragraph
response to the salient characteristics section of this CID shall be provided. The
14
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business