MIL-C-24224B ( SH)
TABLE I.
Classification of defects.
Defects
Categories
Critical:
None defined.
Major:
Material not as specified.
101
Parts missing, damaged, defective, foreign matter
102
present, irregularities or malfunctioning.
Assembly of parts not as specified.
103
Threading not as specified.
104
Protective coating not as specified.
105
Weight not as specified.
106
Dimensions not as specified.
107
Marking not as specified.
108
4.4 Quality conformance tests. Each of the sample cartridges selected in
accordance with 4.2.3 shall be subjected to the tests of 4.5.1 through 4.5.4.
If any cartridge fails one or more of the tests, the lot represented by the
sample shall be rejected.
4.4.1 Quality conformance inspection report. A quality conformance inspec-
tion report shall be repeated by the contractor and provided in accordance with
the data ordering document (see 6.2.2).
4.5 Test procedures.
4.5.1 Gas leakage. Each fully charged gas pressure cartridge shall be
totally immersed in water conditioned at 115°F for a period of not less than
4 hours and examined for C02 leakage. Evidence of leakage shall constitute
failure of this test. Gas cartridges shall be thoroughly dried after the test.
4.5.2 Filling weight. Gas cartridge shall be weighed on a scale graduated
in 1/8 ounce increments with weights being recorded and checked with full weight
stamped on the cartridge. The cartridge seal shall be loosened, allowing the
gas pressure to slowly escape. After all C02 gas has escaped, the cartridge
shall be reweighed to determine the weight of C02 gas which has escaped, thereby
checking the C02 filling against that shown on figure 1.
4.5.3 Safety seal disc. The safety seal disc shall be tested and deter-
mined to rupture between 4,050 and 4,500 pounds per square inch (lb/in*),
internal pressure.
4.5.4 Magnetic test (class 2). Class 2 cartridges shall be subjected to a "
magnetic permeability test using a permeability indicator, low-mu (Go-No-Go) as
specified in MIL-I-17214 to determine conformance with 3.1.
4.6 Inspection of packaging. Preservation , packaging, packing) and marking
shall be inspected to assure compliance with section 5 of this specification.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business